So you think it’s easy….. difficult sawing applications


Using a bandsaw blade to cut a piece of material doesn’t usually cause any problems with that material. However, occasionally, the material causes significant problems for the bandsaw blade!

During the processing and manufacture of metals, heat and stress are applied to form and shape the melt, often leavingĀ residual stresses “built in” due to quick and uneven cooling after casting, forging or rolling resulting in a difficult sawing application. Though from the outside, much of the time the material appears to be stable and still within expected dimensional tolerances, once a saw cut is made that removes (or attempts to) a significant proportion of the material, internal stresses that were balanced within the whole are free to relax and move slightly to a new equilibrium.

The upshot is that often a customer receives a deformedĀ bit of metal, or, it has fractured where the stresses have overwhelmed the strength of the material, or worse, it jams up on the blade in the cut even before it manages to complete the cut! That can be a real headache, but nothing has defeated us yet!

Here are a few of our challenges, and the results of the release of internal stresses. Note, these stresses aren’t just revealed through bandsawing, but any machining process on a non-normalised piece of material can cause a rebalancing of the internal stress in a similar way.

 

Bandsaw blade jammed in a cut

Bandsaw blade jammed in a cut on our Kasto vertical blocksaw

To resist blades jamming in the cut in materials prone to internal stress, it’s important to use a wide set blade to give more clearance on the blade body, and enrich the coolant mixture to reduce friction.

It’s equally important to use a saw with sufficient power to haul the blade through the cut removing material and resisting the clamping pressure on the blade body at the same time.

Blade clamped in key by material stress

Blade clamped in key by material stress on our Kasto blocksaw

 

 

Sawing some material requires more power

Sawing some material requires greater power of Soitaab gantry saw

Resetting the job on our Soitaab gantry saw got us out of trouble. The larger blade motor and heavier saw construction reduces vibration, blade slippage due to bow flexing, and a positive drive from the linear toothed drive rail.

 

17.5 tonne casting cutting

Sawing nimonic alloy castings requires power to ensure the cut completes

Cutting plate and bar material can be equally troublesome…

 

Rectangular bar with internal stress

Rectangular bar with internal stress – thinner the slices bigger the deformation

Rectangular bar with internal stress

Rectangular bar with internal stress

 

In some cases, the stress is sufficient to cause a fracture or breakage of the material. This beam is part of a rail points construction, but when due to a creeping distortion as the cut from one end progressed, we turned it around and started in towards the initial cut, however, the stress relief built and eventually focussed at the remaining material between the two cuts which formed a stress focal point. As you can see, the material could take the strain and fractured.

 

Manganese steel beam for rail points system

Manganese steel beam for rail points system

Manganese steel beam fracture point...

Manganese steel beam fracture point…

Manganese steel beam fracture point close up...

Manganese steel beam fracture point close up…