Amada HI-LO M42 bandsaw blade
Amada HI-LO M42 bandsaw blade
A bandsaw blade with varying tooth height design and an M-42 welded edge blade for metal cutting saws.
A bandsaw blade with varying tooth height design and an M-42 welded edge blade for metal cutting saws.
The Amada HI-LO M42 bandsaw blade features a high and low teeth height design and a 15-degree rake angle. The blade is ideal for cutting hard steels.
Features
15 degree positive rake angle
Hardness of HRC68-69
Patented HiLo tooth design
Specially designed tooth form
Advantages
High heat resistance
High wear resistance
Reduced cutting resistance
Benefits
Fast cutting on difficult to cut materials
Long life on difficult to cut and work hardening materials
Straight cutting
| HiLo | ||
|---|---|---|
| Edge Material | M42 HSS | |
| Hardness of Tooth Tip | 950 Hv | |
| Wear Resistance (1 – 5) | *** | (3 Stars) |
| Chipping Resistance (1-5) | ** | (2 Stars) |
The hardness of the Tooth Tip represent Amada’s average value. It is adjusted to some extent according to the types and size of the products.
| Width | Thickness | Pitch | ||||
|---|---|---|---|---|---|---|
| .75/1 | 1.1/1.5 | 2/3 | 3/4 | 4/6 | ||
| 1″ | 0.035 | V | V | V | ||
| 1 1/4″ | 0.042 | V | V | V | ||
| 1 1/2″ | 0.050 | V | V | V | ||
| 2″ | 0.063 | V | V | V | ||
| 2 5/8″ | 0.063 | V | V | |||
| 3″ | 0.063 | V | V | |||
V: Variable Positive Rake
Specifications may change without notice at the sole discretion of Amada’s Engineering Department.
Related products
Amada PROTEC Matrix bandsaw blade for structurals
...
Amada PROTEC Matrix bandsaw blade for structural steel with matrix edge for use where band saw blade life is importantAmada SIGMA Bimetal bandsaw blade
Amada Sigma M42 Bimetal bandsaw blade with extremely positive rake angle and Hi-Lo tooth geometry especially for hard to cut materials
...Amada Chipbreaker M42 bandsaw blade
M42 chipbreaker bandsaw blade for metal cutting designed to reduce heat generated and increased chip load to remove the most material. With reduced tooth stripping and breaking this equates to the lowest possible cost per square inch of metal cutting.
...
